Project Name

SUPPLY AND INSTALLATION OF 3-WAY FISHER ACTUATOR VALVE AND PRESSURE REGULATOR AT PETRON PANDACAN TERMINAL

Scope of works:

• Supply and purchase of Fisher Actuator Valve and pressure regulator
• Fabrication and installation of tee straight spool
• Pull-out/Re-installation of actuator valve
• Inspection and cleaning of existing valve body
• Assemble of actuator valve
• Bench setting and hydrotesting of fisher valve
• Replacement and installation of pressure regulator
• Replacement and setting of Fisher Fieldvue Instrument  DVC 2000 (Positioner)

Project Name

Lighting Fixtures and Panels Replacement at Calamba Warehouse

Scope of works:

• Erection/removal of Scaffoldings
• Warehouse Perimeter: Removal and replacement of new two (2) units 100W LED Floodlights (Weatherproof)
• Office Perimeter: Removal and replacement of new two (2) units Weatherproof LED Lighting Fixtures
• Inspection Area: Removal and replacement of new Four (4) units Weatherproof LED Lighting Fixtures
• Warehouse Ceiling: Removal and replacement of new twenty five (25) units LED Lighting Fixtures
• Mezzanine Ceiling: Removal and replacement of new twenty four (2) sets of Philips fluorescent light with starter
• Removal and replacement of new six (6) units 2‐gang switches at the warehouse
• Removal of old fuse box, Installation and rewiring of new 125Amps Schneider Main Circuit Breaker
• Removal and Installation of new Weatherproof LED Lighting fixture at office entrance
• Removal and Installation of new fluorescent light at office pantry
• Repair and rewiring of old lighting fixture and installed at guard post area

Project Name

Diesel Genset No. 1 Cummins KTAA 38-G9 Servicing and Installation of Radiator

Scope of works:

• Replacement of front and rear crankshaft oil seals
• Replacement of fuel filters, oil filters and water coolant filters
• Engine Change Oil
• Cleaning of Daily fuel Tank
• Rectification of engine leaks
• Replacement of fan belt and alternator belt
• Adjustment of intake and exhaust valve
• Installation of thermostat at left bank and right bank
• Replacement of New Radiator

Project Name

Inspection and Reconditioning of VI Bottom Mixer Agitator Motor

Scope of works:

• Pre‐inspection of Equipment conditions
• Pull‐out/Re-installation of Drive Motor
• Motor Solo Run and Inspection
• Dis‐assemble/Assemble of Motor Parts
• Replacement of DE/NDE Bearings of motor
• Lubrication of motor bearings
• Inspection and Varnishing of motor windings (Additional)
• Electrical Inspection (Resistance check, voltage, wiring connection and others)

Project Name

Replacement and installation of brush roll